自上料搅拌车的轮胎多久换一次？_行业资讯_自动混凝土搅拌机知识_自动混凝土搅拌机_自动混凝土搅拌车厂家

站内搜索

自动混凝土搅拌机知识

公司新闻行业资讯

热点

自动混凝土搅拌机遇到活塞敲缸的处理方法!

2021-01-31

如何防止全自动搅拌车粘罐现象的出现？

2020-06-17

自动上料搅拌车的正确刹车步骤！

2021-02-15

如何避免全自动搅拌车堵料的问题？

2022-02-18

关于山汽

联系人：刘老师

电话：400-879-1999

公司：山东山汽工程机械（集团）有限公司

地址：山东省莱州市206国道与308省道交叉口东南50米

自上料搅拌车的轮胎多久换一次？

所属分类：行业资讯发布时间：2021-03-24 来源：http://www.sqjituan.cn/ 浏览量：0

随着自上料搅拌车成本的持续提升，轮胎的也跟着上涨，如果使用不当导致非正常损耗，对车主的钱包来说是个打击。那么自上料搅拌车的轮胎多久换一次呢？下面我们一起来了解一下。

With the continuous increase of the cost of the self feeding mixer, the price of the tires also increases. If improper use causes abnormal loss, it is a blow to the wallet of the owner. How often do you change the tires from the loading mixer? Now let's take a look.

1.轮胎胎面花纹深度

1. tread depth of tire

胎面花纹的厚度一定要大于1.6毫米，如果你经常驾车行驶在摩擦力低的湿滑路面上，尽量能保证胎面花纹厚度是上述数值的两倍。你可以学习人士，购买一个计量器来测量胎面花纹的厚度；然而老驾驶员常使用一种广为流传的办法来大致估计胎面花纹厚度，那就是拿出一枚一元硬币，顺着国徽顶端方向插入胎面沟壑中，因为硬币边缘到国徽顶端的距离在1到2毫米之间，所以如果这时还可以看到整个国徽标志，说明胎面花纹厚度已经不足。

The tread thickness must be greater than 1.6mm. If you drive frequently on a wet slippery road with low friction, try to ensure that the tread thickness is twice the above value. You can learn from professionals and buy a gauge to measure the tread thickness; however, the old driver often uses a widely used method to estimate the tread thickness roughly, that is to take out a dollar coin and insert it into the tread groove in the direction of the top of the national emblem, because the edge of the coin goes to the country The distance between the top of the emblem is between 1 and 2mm, so if the whole national emblem can be seen at this time, the tread pattern thickness is insufficient.

2.胎面花纹磨损指示线

2. tread pattern wear indicator line

新款轮胎比过去的老式产品多了一项人性化设计：胎面花纹磨损指示线。当轮胎非常新或磨损程度很低的情况下，这些指示线几乎不会被发觉，但当磨损到达一定程度这些隐藏在胎面沟壑中的指示线就呈现出来。胎面花纹磨损指示线为扁平的橡胶条，与胎面纵向垂直镶嵌在胎面沟壑中。当你检查轮胎可以偶尔发现一到两条指示线的时候，说明胎面花纹厚度已经减少了很多，这种情况下行驶在湿滑路面上就要格外小心了。如果轮胎上的几乎所有指示线都清晰可见，意味着你需要尽快更换轮胎了。

The new tyre has a more humanized design than the old ones in the past: tread pattern wear indicator line. When the tires are very new or wear is low, these indicators are hardly detected, but when the wear reaches a certain extent, these indicators hidden in the tread gully appear. The tread pattern wear indicator line is flat rubber strip, and is vertically embedded in the tread groove vertically with the tread. When you check the tires and you can occasionally find one or two indicator lines, it means that the tread thickness has been reduced a lot, so you should be careful when driving on wet road. If almost all of the indicator lines on the tire are clearly visible, it means you need to change the tires as soon as possible.
自动混凝土搅拌车

3.轮胎侧壁裂纹

3. crack on the sidewall of tire

轮胎上存在的问题并不是全部集中在胎面上，轮胎侧壁也会出现一些毛病。通过观察查找轮胎侧壁上那些肉眼直接可见的裂痕和切口。这些细小的沟槽预示着轮胎上未来可能出现的漏气裂缝，更糟的话甚引发轮胎的爆裂，这些轮胎故障都是我们希望避免的。所以在轮胎侧壁裂纹看起来比较严重的时候，还是以快速度把车辆开往维修厂更换轮胎为上策。

The problems on the tire are not all concentrated on the tread, and some problems will occur on the sidewall of the tire. Observe and find the cracks and cuts on the sidewall of the tire that are directly visible to the naked eye. These tiny grooves indicate the possible future air leakage cracks on the tires, and even cause the burst of the tires, which we hope to avoid. So when the side wall crack of the tire appears to be serious, it is better to drive the vehicle to the repair factory and replace the tire at a fast speed.

4.轮胎上的凸起和起泡

4. bulge and blister on tire

有些情况下，轮胎的外表面会因为强度不够，导致高出正常轮胎表面的凸起和起泡。这就如同血管中出现的动脉瘤，轮胎也面临类似的状况，如果你没能及时把车辆送往维修厂检测轮胎故障，胎面上强度不足的区域很有可能引发突然的爆裂，高速行车下的轮胎爆裂甚会导致驾乘人员出现严重的伤病。

In some cases, the outer surface of the tire will be raised and bubbled higher than the normal tire surface due to insufficient strength. This is like an aneurysm in the blood vessel, and the tire is facing similar conditions. If you fail to send the vehicle to the repair factory to detect the tire failure in time, the area with insufficient strength on the tread may cause sudden burst. The burst of tires under high speed driving may even cause serious injuries to the driver.

车辆前行过程中出现一定量的抖动是不可避免的，特别是在道路状况较差的条件下。当你已经有了一定驾驶经验的时候，你可以通过感受自己判断出怎样的抖动在合理范围内，以及怎样的抖动说明车辆存在故障。

It is inevitable that a certain amount of jitter occurs during the process of vehicle moving forward, especially in the condition of poor road conditions. When you have some driving experience, you can judge by yourself what kind of jitter is within a reasonable range and what jitter means the vehicle has a fault.

上一页：如何自上料搅拌车零配件的噪音问题？下一页：混凝土搅拌车发动机怠速判断及办法？

热门产品 / HOT PRODUCT