自上料搅拌车是工地用车,这种车的车型比较大,所以在出车前一定要注意检查,以防万一。
The self loading mixer is used on the construction site. The model of this kind of vehicle is relatively large, so you must pay attention to inspection before driving, just in case.
1、细心检查及时发现排除故障。
1. Check carefully and find and eliminate faults in time.
千万不能让自动上料搅拌车坏在路上,否则出现闷罐就麻烦了,混凝土一般停罐不能超过2个小时,C40往上级别的混凝土基本就不能停。点火之前先检查机油、防冻液、润滑油和冷却水等,发现不足时,应重新进行添加。车子启动后,再让罐子低速旋转,围绕着车检查轮胎气压,是否有漏气的胎,再用螺丝刀剔掉在胎缝里的石子,检查是否有铁钉之类扎在胎里!
Do not let the automatic loading mixer break down on the road, otherwise it will be troublesome to stuffy the tank. Generally, the concrete tank can not be stopped for more than 2 hours, and the concrete of C40 level can not be stopped. Check the engine oil, antifreeze, lubricating oil and cooling water before ignition. If it is insufficient, add it again. After the car starts, let the jar rotate at a low speed, check the tire pressure around the car, check whether there is a leaking tire, and then remove the stones in the tire seam with a screwdriver to check whether there are iron nails or the like stuck in the tire!
再检查灯光,尤其是腰灯,务必保证照着轮胎边缘,工地会经常乱堆放钢筋之类的东西,而胎侧是非常薄弱的。用抹布擦干净两边的后视镜,窗户玻璃,工地路况复杂,光线不好,视线一定要保证! 自上料搅拌机2、保证水箱里有足够的水,有减水剂,因各种原因料太干,没有水添加放不出料的时候,减水剂就是救命稻草了。
Check the light, especially the waist light, to ensure that it shines on the edge of the tire. The construction site will often pile up reinforcement and other things, and the sidewall is very weak. Wipe the rear-view mirrors and window glass on both sides with a rag. The road conditions on the construction site are complex and the light is bad. The line of sight must be guaranteed first! Since the feeding mixer 2, ensure that there is enough water in the water tank and water reducing agent. When the material is too dry for various reasons and there is no water to add, the water reducing agent is a life-saving straw.
3、确认搅拌罐处于停止状态,因为发动机启动时万一罐子处于高速旋转状态,瞬间的力会很大的,伤减速机。
3. Confirm that the mixing tank is in the stop state, because if the tank is in the high-speed rotation state when the engine is started, the instantaneous force will be great and damage the reducer.
4、无论是将手柄从搅拌到排放还是从排放到搅拌,都应使其停止在停止位置,然后拨到下一个操作位置。
4. Whether the handle is from mixing to discharge or from discharge to mixing, stop it at the stop position, and then turn it to the next operation position.