全自动搅拌车的检测步骤和油泥产生的影响是怎样的？_公司新闻_自动混凝土搅拌机知识_自动混凝土搅拌机_自动混凝土搅拌车厂家

站内搜索

自动混凝土搅拌机知识

公司新闻行业资讯

热点

小型搅拌机的使用功率是多少？

2020-11-16

全自动搅拌车有哪些新的功能？

2021-11-15

自动混凝土搅拌车的保养要注意哪些地方？

2020-08-07

混凝土搅拌机每次清洗养护都检查哪些？

2020-07-06

关于山汽

联系人：刘老师

电话：400-879-1999

公司：山东山汽工程机械（集团）有限公司

地址：山东省莱州市206国道与308省道交叉口东南50米

全自动搅拌车的检测步骤和油泥产生的影响是怎样的？

所属分类：公司新闻发布时间：2022-02-25 来源：http://www.sqjituan.cn/ 浏览量：0

在引入全自动搅拌车检测步骤时，让每个人都知道一些未知的问题或知识，但我们对我们所在的行业仍然相对不熟悉。今天我们将逐渐明白：

When introducing the detection steps of automatic mixer truck, let everyone know some unknown problems or knowledge, but we are still relatively unfamiliar with our industry. Today we will gradually understand:

1.电池维护检查：检查电池是否牢固固定。

1. Battery maintenance inspection: check whether the battery is firmly fixed.

2.轮胎检查：每月应检查室温下的轮胎压力。

2. Tire inspection: check the tire pressure at room temperature every month.

3.离合器主泵水位检查：离合器液位高低液位表示正常，如果低于标准线，则可能是主泵或泵碗损坏。

3. Water level inspection of clutch main pump: the high and low level of clutch liquid level indicates that it is normal. If it is lower than the standard line, the main pump or pump bowl may be damaged.

4.检查制动液液位：制动液在高低之间也正常。

4. Check the brake fluid level: the brake fluid is normal between high and low.

5.发动机冷却液液位检查：当发动机处于高温状态时，不要打开散热器盖，否则可能会被飞溅的冷却液或高温蒸汽灼伤。发动机冷却后，检查冷却液的液位应在满和低之间。否则，应加入蒸馏水或纯净水或冷冻液。加水后液体的高度不应超过满水位。如果发现冷却液在短时间内迅速降低，则自动混合器检查步骤应检查冷却系统是否有泄漏或者到维修站进行检查。

5. Engine coolant level inspection: when the engine is at high temperature, do not open the radiator cap, otherwise you may be burned by splashing coolant or high-temperature steam. After the engine is cooled, check that the coolant level should be between full and low. Otherwise, distilled water or purified water or frozen liquid shall be added. The height of the liquid after adding water shall not exceed the full water level. If the coolant is found to decrease rapidly in a short time, the automatic mixer inspection step should check whether the cooling system has leakage or go to the maintenance station for inspection.

全自动搅拌车驱动器介绍

Introduction of automatic mixer driver

驱动器用于驱动混凝土罐的旋转。它由动力输出单元，万向轴，液压泵，液压马达，控制阀，液压油箱和冷却装置组成。对于全自动搅拌车，驱动器仍然非常重要，所以让我们仔细看看。

The driver is used to drive the rotation of the concrete tank. The utility model is composed of a power take-off unit, a universal shaft, a hydraulic pump, a hydraulic motor, a control valve, a hydraulic oil tank and a cooling device. For the fully automatic mixer, the driver is still very important, so let's take a closer look.

1.通用车削部件是故障部件。应及时填充润滑脂，并经常检查磨损情况，并及时修理和更换。车队应该有一个备用万向轴组件，以确保在发生故障时几分钟内恢复。

1. General turning parts are faulty parts. The lubricating grease shall be filled in time, and the wear shall be checked frequently, and repaired and replaced in time. The fleet should have a spare cardan shaft assembly to ensure recovery within minutes of failure.

2.确保液压油清洁。全自动搅拌车的工作环境不好，一定要防止脏水泥砂进入液压系统。应根据手册的要求定期更换液压油。一旦检查发现水或沙子混入液压油中，立即停止液压系统并更换液压油。

2. Ensure that the hydraulic oil is clean. The working environment of the full-automatic mixer is not good, so we must prevent the dirty cement sand from entering the hydraulic system. The hydraulic oil shall be changed regularly according to the requirements of the manual. Once water or sand is mixed into the hydraulic oil, stop the hydraulic system and replace the hydraulic oil immediately.

3.确保液压油冷却装置有用。定期清洁液压油散热器，防止散热器被水泥堵住，检查散热器风扇是否正常运转，防止液压油温度超标。只要液压元件确保液压油清洁，通常几乎没有故障，但制造商具有不同的使用寿命。

3. Ensure that the hydraulic oil cooling device is useful. Clean the hydraulic oil radiator regularly to prevent the radiator from being blocked by cement, and check whether the radiator fan operates normally to prevent the hydraulic oil temperature from exceeding the standard. As long as the hydraulic components ensure that the hydraulic oil is clean, there is usually almost no failure, but the manufacturer has different service life.

一般情况下，如果驱动器由于故障停止工作，混凝土水箱将不能正常旋转，这将导致车辆中的混凝土报废，甚整个水箱混凝土将在水箱中冷凝，导致全自动搅拌车报废。因此，驱动装置是否可靠是在使用中高度重视的问题。

Generally, if the driver stops working due to failure, the concrete water tank will not rotate normally, which will lead to the scrapping of the concrete in the vehicle, and even the concrete in the whole water tank will condense in the water tank, resulting in the scrapping of the full-automatic mixer. Therefore, whether the driving device is reliable or not is a problem of great importance in use.

以上对于全自动搅拌车的检查步骤和油泥带来的影响介绍就是这样了，希望对你有帮助。

This is the above introduction to the inspection steps of automatic mixer and the impact of oil sludge. I hope it will be helpful to you.

以上就是今天带给大家的知识，全自动搅拌车专注行业多年，为用户不断的提供有价值的内容，更多内容请继续关注我们：http://www.sqjituan.cn

The above is the knowledge brought to you today. The full-automatic mixer has focused on the industry for many years and continuously provides users with valuable content. Please continue to pay attention to us for more content: http://www.sqjituan.cn

上一页：全自动搅拌车是怎么自动上料的？下一页：全自动搅拌车的减速机漏油如何维修要领

热门产品 / HOT PRODUCT