混凝土自动混凝土搅拌车在使用之后也要定期清理罐内、罐外等,避免废料堆积等其他问题,下面简单了解下手动擦洗的几点步骤如何:
After using the automatic concrete mixer, the inside and outside of the tank should be cleaned regularly to avoid other problems such as waste accumulation. Here are some steps of manual scrubbing
1.用湿毛巾从汽车顶部擦拭测试,擦去灰尘,然后从顶部到底部逐渐擦拭车窗和护罩上的灰尘。擦去污垢。毛巾不能用沙子擦拭,否则会在胶片表面和玻璃上刮擦或刮擦。
1. Wipe the test with a wet towel from the top of the car to remove the dust, and then gradually wipe the dust on the window and shield from the top to the bottom. Wipe off the dirt. Towel can not be wiped with sand, otherwise it will scratch or scratch on the film surface and glass.
2.将毛巾浸入水中,然后从屋顶向下慢慢浸湿整个身体。
2. Immerse the towel in the water, and then slowly wet the whole body from the roof down.

3.如果有很多污垢,可以先用软毛刷刷一下,然后用水冲洗,然后再用毛巾擦洗。
3. If there is a lot of dirt, you can brush it with a soft brush first, then rinse it with water, and then scrub it with a towel.
4.使用干净的干毛巾以上述方式再次擦拭车身,直到擦拭干净为止,不得留下任何污垢和水印。
4. Use a clean dry towel to wipe the car body again in the above way until it is clean, without leaving any dirt and watermark.
5.再次擦洗车身后,请仔细检查是否有残留的灰尘。如果是这样,请立即再次擦拭尖端,直到将其清洁。
5. After cleaning the car again, please carefully check whether there is residual dust. If so, wipe the tip again immediately until it is clean.
Thank you for reading, hope the above content can help you, if you want to know more wonderful content, please click our official website: automatic concrete mixer http://www.sqjituan.cn .