自上料式混凝土搅拌机的使用是有目共睹的,在城市建设运营中也发挥着举足轻重的重要地位,然而在日常的使用过程中,同样也要做好泵车的维护保养工作。自上料式混凝土搅拌机是城市建设道路、桥梁、房屋、水利工程、搅拌站等不可或缺的运输工具,而搅拌筒在这之中也占据着举足轻重的重要地位。
The use of self loading concrete mixer is obvious to all, and it also plays an important role in urban construction and operation. However, in the daily use process, it is also necessary to do a good job in the maintenance of pump truck. Self loading concrete mixer is an indispensable professional transportation tool for urban construction roads, bridges, houses, water conservancy projects, mixing stations and so on, and the mixing drum also plays an important role in this.
1.每次泵芯清洗完毕,必须加入少许硅油润滑及防绣,其目的以保护转芯不会锈蚀及下次使用起动顺利。
1. Every time the pump core is cleaned, a little silicone oil must be added for lubrication and anti rust, so as to protect the rotor core from corrosion and the next use and start smoothly.
2.机器工作时,电箱门必须关闭锁好,以防灰尘及水分侵入,损坏机器元件。
2. When the machine is working, the door of the electric box must be closed and locked to prevent dust and moisture from invading and damaging the machine components.
3.每天工作前或工作后轴承座必须加油并且经常检查减速箱机油。
3. The bearing seat must be filled with oil before or after work every day, and the oil in the gearbox must be checked frequently.
4.在施工现场移动机器时,不论远近,必须先拔电源线。
4. When moving the machine at the construction site, no matter how far or near, the power cord must be pulled out first.
5.清洗机器时,电箱部分只可擦拭,不可冲洗。
5. When cleaning the machine, the electric box can only be wiped, not washed.
6.主轴密封圈压盖调正,必须将泵芯和送料撑脱离,然后上紧三个螺杆,螺杆上紧后的标准:以8寸活手轻松扳动主轴螺丝为准。
6. When adjusting the gland of the main shaft sealing ring, the pump core and the feeding support must be separated, and then the three screws must be tightened. The standard of screw tightening is that the 8-inch movable hand can easily pull the main shaft screw.
自上料式混凝土搅拌机的选型应根据混凝土工程对象、特点、及要求的输送距离、混凝土建筑计划、混凝土泵形式以及具体的条件行综合考虑。自上料式混凝土搅拌机的搅拌筒应设置1一2个能快速打开的人口,孔径不小于450mm,在椭圆形孔的情况下,其短径不应小于350mm,关闭时应密封良好;搅拌筒在各种规定的使用状态下,应转动平稳,不得有打颤和振动现象;搅拌叶片与筒体应焊接牢固,螺旋曲线应连接,不应有明显拐点。
The selection of self loading concrete mixer should be comprehensively considered according to the concrete project object, characteristics, required conveying distance, concrete building plan, concrete pump form and specific conditions. The mixing drum of self loading concrete mixer shall be equipped with one or two quick opening cylinders with a diameter of not less than 450mm. In the case of oval hole, its short diameter shall not be less than 350mm, and it shall be well sealed when closed; The mixing drum shall rotate smoothly without chattering and vibration under various specified conditions; The mixing blade and cylinder should be welded firmly, the spiral curve should be connected, and there should be no obvious inflection point.
自上料式混凝土搅拌机的性能是随机型而异,选用机型之时除了考虑混凝土浇注量以外,还应当考虑到建筑的类型和结构、施工技术的要求、现场条件和环境等等。通常选用的混凝土泵车的主要性能参数应当与施工要求相符或稍大,若能力过大,则利用率低,过小,不仅满足不了要求还会加速混凝土泵车的损耗。
Since the performance of the loading concrete mixer is different from that of the random type, in addition to the amount of concrete pouring, the type and structure of the building, the requirements of the construction technology, the site conditions and the environment should also be considered when selecting the type of concrete mixer. Generally, the main performance parameters of the selected concrete pump truck should be consistent with the construction requirements or slightly larger. If the capacity is too large, the utilization rate is low, too small, not only can not meet the requirements, but also accelerate the loss of concrete pump truck.